Fostex D2424LV manual Preparation for the current drive, Installing a hard disk in the caddy

Page 6

Model D2424LV Quick Operation Guide

Preparation for the current drive

The D2424LV has a slot for an optional hard disk. First you need to install a hard disk into the caddy included in this recorder package before you install it into the slot.

The following instructions assume that you have already purchased an E-IDE hard disk unit. Prepare the following items for hard disk installation:

Hard disk unit

Fixing screws

Caddy

<Note>

Be sure to turn off the power to the D2424LV (or remove the power cable from the AC outlet) before installing a hard disk.

Installing a hard disk in the caddy

First, you need to disassemble the caddy included in the package so that you can install a hard disk into it.

• Disassembling the caddy

1.Apply your thumb to the edge of the case on the connector side as shown in the figure, and slightly pull the cover in the direction of the arrow.

2.Apply your thumbs to the side of the case and open the cover. In the same manner, open the cover on the other side. (Caution: Be careful not to pinch your fingers.)

<Notes on handling a hard disk>

•A hard disk is a high-precision device. Do not apply any impact to the disk when and after you install it in the caddy. Do not leave the disk near a device that generates a strong magnetic field. Choose a level and stable surface for installation. Be careful not to injure yourself.

Fostex is not liable for any malfunction or damage to the hard disk caused by mishandling.

•You need to set the DIP (Jumper) switch on the hard disk to “Master” before you install it into the caddy. If the switch is set to “Slave,” the hard disk will not function correctly.

Refer to the instruction manual that came with your hard disk for more information on the DIP (Jumper) switch setting.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Quick Operation Guide Model D2424LV Quick Operation Guide Safety Instructions Contents Package contents Recording mediaInstalling a hard disk in the caddy Preparation for the current driveDisassembling the caddy Connecting cables Fixing the hard disk to the caseAssembling the case Installing the removable case in the recorder Connecting a detachable controllerTurn the power on Sampling frequencyPress the EXECUTE/YES key Format type Program Time BaseSetup of the Internal Clock Press the Setup key while in the stop modeConnecting a analog mixer Analog mixerConnecting a digital mixer Digital mixerInitial settings About Sampling FrequencyHints Basic analog recording Adjusting the recording levelBasic recording Stopping recordingTo cancel the undo operation, press the UNDO/ Redo key again Undo and redo recording single undo/redoSelecting Digital Out Basic digital recordingSelecting Digital About Digital In selectionSetting the reference clock About reference clock settingPress the EXIT/NO key or Stop button to exit the Setup mode Press the Record button once Multitrack recording using overdubbingPing-pong recording PlaybackLocating the top of the Program MixdownBasic Locate function Locating the end of the recorded area of the ProgramRecording in a new Program Selecting the desired ProgramChanging the program FS Current drive formatting by 24bitCurrent drive formatting by 16bit Set the desired pitch data using the Jog dial Playback using theVari-pitch functionVari-pitch function procedures Press the Recall key, then press the Vari Pitch keyReference manual reference pages Declaration of EC Directive Memo Fostex Corporation
Top Page Image Contents