Gefen GTV-WHD-1080P-LR-BLK user manual Renaming Sources

Page 19

OPERATING THE WIRELESS FOR HDMI

Renaming Sources

By default, each Sender unit is assigned the name “Sender”. This can be confusing when multiple Sender unit are used. However, this identiﬁer can be changed to reﬂect, for example, the source to which each Sender unit is connected.

1.Point the IR Remote Control at the Receiver unit, press the MENU button, select Modify Video Source Name, then press the OK button.

Setup

Add new Video Source

Remove Video Source

Modify Video Source Name

Disconnect Wireless Link

2.Select the source to rename from the menu by using the cursor keys:

Choose Source to Rename

Sender

Sender

15

Image 19

Contents Wireless for Hdmi Page Write To Asking for AssistanceTechnical Support Technical Support HoursContents Introduction About Gefen GefenTV Wireless for Hdmi Multi-Room SolutionInstruction to the User FCC StatementOperation Notes Operation Notes Package Includes FeaturesHdmi Features Supported FeaturesPanel Layout Receiver unit Front Back Sender Unit Panel DescriptionsReceiver Unit Layout and Descriptions IR Remote Control UnitHow to Connect the Wireless for Hdmi Multi-Room Solution Connecting the Wireless for HdmiLinking Process Operating the Wireless for HdmiAdding a new Video Source Using Multiple Sender UnitsPress the OK button to continue adding the Sender unit Adding Sender Renaming Sources Available characters for source naming Select Video Source Sender Switching between Sources STB Deleting Sources After a few seconds, the screen will go blank DVR Connecting to... status message will be displayed Disconnecting the Wireless Link Reconnecting the Wireless Link Power-Down Mode Powering-Up after a Power-Down Specifications Product Registration WarrantyPage Page Page Rev A3 Nordhoff St., Chatsworth CA