Panel Descriptions

Front Panel

Back Panel

1Power LED

This LED will activate once a valid power source is applied.

2Internal EDID LED

This LED will activate only when the pre-programmed internal EDID is being used. Please see page 6 for more details on the internal EDID.

3External EDID LED (default EDID routing)

This LED will activate only when the external EDID is being used. Please see page 6 for more details on the external EDID.

4Link LED

This LED will activate when a valid link between the source and the splitter is detected.

5EDID Button

This button will activate the onboard EDID. Press this button (the Int. EDID should turn on and the Ext. LED should turn off) and reset the unit using the Reset button (below) to initialize this EDID mode. To use an external EDID, press the EDID button again (the Int. LED should turn off and the Ext. LED should turn on) and press the Reset button to initialize this EDID mode.

6Reset Button

This button will reset the unit and initialize whichever EDID mode is currently selected.