Elite Screens F84NWV Pulling down the screen, Retract the screen, Pulling out the support rod

Page 6

Preparing screen for storage

1.Pulling down the screen:

First, hold the telescoping support rod with the left hand and loosen the locking sleeve counter-clockwise with the right hand. Then shorten the telescoping support rod slowly into the full retracted position and tighten the locking sleeve to secure it in place.

2.Retract the screen:

Remove the pull hook from the support bracket by lifting it about 2 cm up and then hold on to the pull hook and lower the screen gently into the box.

3.Pulling out the support rod:

After telescoping the small supporting rod to its shortest position and tightening the locking sleeve, take out the supporting rod from the support plate.

Rev. 1.0

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Elite ez Cinema Series Parts Identification Installation Extend the base feetOpen the box cover Installing the support rodVertical Adjustment Pull up the screenAdjusting the screen Pulling down the screen Retract the screenPulling out the support rod Storing the support rod Draw the base feet backStoring the screen Please visit the link below for full warranty information TWO WAY to Register Your Warranty with Elite Screens INC Elite ez Cinema Plus Series Precautions Extend base feet Pulling up the screenRetract the screen into case Closing it upDraw the base feet back Storing the screen TWO WAY to Register Your Warranty with Elite Screens INC
Top Page Image Contents