Elite Screens manual Control System for CineTension 2 Series

Control System for CineTension 2 Series

1.5-12V Trigger: The built-in 5-12V trigger input allows your screen to synchronize its drop & rise with the projector’s power cycle. The screen deploys when the projector powers up and will retract when the projector powers down. The 5-12 volt adaptor connects to your projector’s trigger output via a separate cable that may or may not be provided by the manufacturer of the projector. The trigger feature will not work without an output cable from the projector, but it can be tested by connecting the Red (+) and Green (-) cable to a 9-volt battery.

Red: DC 12 +

Green: 0 V -

3-prong power cable

RJ-45 input for 5-12V Trigger

2.3 -Way Wall Switch: The 3-way wall switch is a wall mount control box with an up/stop/down button and plugs directly into the screen’s RJ-45 input.

5-12 Volt Trigger Cable

3.IR “Eye” Receiver: The IR “Eye” Receiver plugs directly into the screen’s RJ-45 input to present a low profile line-of-sight control option for your IR remote control even in a recessed ceiling installation.

3-way Wall switch IR “Eye” Receiver

4.IR Remote Control: The Infrared functions by direct line of sight contact with a beam range of 30 feet.

5.RF Remote Control: The radio waves eliminate the need for a direct line of sight with a range of 150 feet.

UP

Stop

Down

5

Rev.102111-AS
www.elitescreens.com	info@elitescreens.com