OTHER ADJUSTMENTS (Continued)
• Minimizing phosphor | for RGB |
You can use this option to move the screen position to minimize
Follow the steps below.
(1)Select “Screen Orbiter” and press <.
The “Screen Orbiter” setting screen will appear.
(2)Press Cor Dto select “Mode/Time”.
(3)Select a desired pattern.
Each time you press Eor F, one of the available choices appears in the following sequence:
“Screen Orbiter” setting screen
[Off]: Disables Screen Orbiter.
[Time]: Moves the pattern approximately every one hour.
[Mode]: Moves the pattern when the power is turned ON or when you switch between modes.
(4)Press Cor Dto select “Moving Area”.
(5)Press Eor Fto select the range for moving the pattern.
Each time you press Eor F, one of the available choices appears in the following sequence:
[Min.]: Pattern moves in small range. (About 5 pixels)
[Std.]: Pattern moves in moderate range. (About 10 pixels)
[Max.]: Pattern moves in wide range. (About 15 pixels)
(6)Press <to store.
*When the Screen Orbiter function is operated, some letters at the top, bottom, right or left of the screen may be missed.
• Setting RGB Input Signal Compulsorily (Direct Setting) | for RGB |
You can use this option to switch the setting for RGB input signal.
Each time you press Eor F, one of the available choices appears in the following sequence:
[Auto]: The optimum display is obtained automatically for input signals.
[Others]: The optimum resolution setting is fixed for each signal. Press <to store.
*In Auto mode, the resolution of VGA, WVGA, 480P, XGA, WXGA, SXGA and SXGA+ may not be automatically distinguished. Switch to the fixed display when the image is not displayed properly.
*Signals that are not applicable depending on the model or input terminals may not be displayed.
• Specifying RGB Input Signal (Code Setting) | for |
Normally, use this option in Auto mode.
•Displaying white over entire screen (White Screen)
You can use this option to display white over the entire screen to minimize phosphor
On Off
Press <to store.