Stewart Filmscreen Corp Projection HDTV Attaching the Screen to the Frame

Page 8

ATTACHING THE SCREEN TO THE FRAME

This section provides instructions for attaching the screen to the frame.

Caution

‹Be sure your hands and clothing are clean. Use of gloves is recommended. Be careful not to touch or scratch the image surface with fingernails.

‹Do not use any tools to fasten the screen to the frame.

‹Do not fold or crease the screen.

You will need at least two people, one to support the screen, and one to snap the screen in place. The viewing side of the projection screen is rolled to the inside to protect the optical coating. The screen is rolled lengthwise, with protective paper rolled in with the screen. The screen fabric attaches to the frame with snap fasteners.

1.Remove the screen from the cardboard shipping tube.

2.Look at the frame and locate the snaps.

3.While supporting the screen roll, snap the screen into the frame starting at the top left. Gently allow the screen to stretch onto the snaps. Do not jerk the material, as it can rip. Refer to Figures 3 and 4. Attach the snaps on the top corners and top horizontal section first, unrolling the screen as you go. Attach remaining snaps.

Figure 3: Unrolling the screen for attachment to the frame

Figure 4: Details of screen attachment

6

Stewart Filmscreen Corporation

Image 8
Contents CineCurve Page Contents To the Owner About the CineCurveUnpacking Preparing the InstallationPreparation CineCurve components Frame Assembly and Wall Mount Unassembled frame rear viewAttaching the Screen to the Frame Unrolling the screen for attachment to the frameScreen Care and Cleaning General maintenanceReplacement parts and service Operating the CinecurveProduct Warranty Troubleshooting Problem description Probable cause Action to take