Stewart Filmscreen Corp Projection HDTV installation instructions Frame Assembly and Wall Mount

Page 7

FRAME ASSEMBLY AND WALL MOUNT

Professional mounting techniques should be used. Stewart Filmscreen Corporation cannot be liable for substandard or faulty installations.

This section describes assembly and mounting of the CineCurve frame. Refer to Figure 2.

1.Assemble the frame by fitting together the slip joints of the side sections and center section. The sections are number matched. Secure the sections using the supplied hex head bolts.

2.Attach the center wall mount bracket to the frame.

3.Mount the frame to the wall. If possible, attach to wall studs. Alternately, use hollow wall anchors or molley bolts appropriate for the weight of the screen and frame assembly.

4.Make sure the frame is level and plumb.

5.Ensure that after you attach the screen you can access the motor and encoder cables for attachment to the BRIC controller.

6.When you are ready to connect the motor and encoder cables, refer to the BRIC manual.

Slip joint

Wall brackets

Figure 2: Unassembled frame; rear view

CineCurve: Owner’s Manual

5

Image 7
Contents CineCurve Page Contents About the CineCurve To the OwnerPreparation Preparing the InstallationUnpacking CineCurve components Unassembled frame rear view Frame Assembly and Wall MountUnrolling the screen for attachment to the frame Attaching the Screen to the FrameOperating the Cinecurve Screen Care and CleaningGeneral maintenance Replacement parts and serviceProduct Warranty Problem description Probable cause Action to take Troubleshooting