Operating the Cinecurve

CineCurve operation is controlled by a Stewart Filmscreen BRIC. Refer to the BRIC manual for details. You can use either a hand-held remote control or a wall mounted keypad to operate the masks.

Caution

Keep objects and fingers out of the way of the masks when they are in motion.

SCREEN CARE AND CLEANING

General maintenance

The surface of your screen is delicate. Special attention to these instructions should be followed when cleaning.

A draftsman-style brush may be used to lightly whisk away any loose dirt or dust particles. (This type of brush is usually available at office supply stores.) Stewart Filmscreen has an optional screen cleaning kit that contains the proper type of brush. Contact your dealer if you would like to obtain this cleaning kit.

For tougher spots, use a solution of mild detergent and water. Rub lightly using a sponge. Blot with a damp sponge to absorb excess water. Residual water marks will evaporate within a few minutes.

Do not use any other cleaning materials on the screen. Contact the factory if you have questions about removing difficult spots.

Caution

Do not use chemicals or liquid to clean the fabric.

VeLux covering

Use a lint roller to remove particles from the VeLux material.

A brush can be used to comb (lift) the nap of the VeLux material to help eliminate depression marks.

Replacement parts and service

No user-serviceable parts are contained within the unit. Contact your dealer or the factory if you require part replacement or service.

CineCurve: Owner’s Manual