Tatung TLM1905, TLM-1705 manual Preface

Page 3

PREFACE

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Opeartion is subjected to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

FCC WARNING

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inerference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the shielded signal cord supplied with this unit.

i

Image 3
Contents Operating Instructions Page Preface Radio Frequency Interference Statement Important Operating Instructions Introduction Standard Item UnpackingLCD Multimedia Monitor Front View Identifying ComponentsTilting the Monitor Adjusting the Tilting AnglePage Power Management System LCD Multimedia Monitor Control Panel Display ControlsMONITOR-CONTROL Option Adjusting the Monitor’s DisplayOSD-CONTROL Option MISC-CONTROL Option GRAPHIC-CONTROL OptionOSD Exit Option Digital Mode OptionalOSD-CONTROL Option Video or S-VIDEO Mode VIDEO-CONTROL Option MISC-CONTROL Option No Video Auto-adjusthot-key button Hot-Key Buttons for Quick Adjustment of MonitorTroubleshooting Procedures TroubleshootingProblem There is no Video Signal Technical Information LCD Monitor SpecificationsRelative Humidity Altitude 0-12,192m Supported Timing Tatung Company of America