Tatung TLM1905, TLM-1705 manual Important Operating Instructions

Page 5

Important Operating Instructions

Please read the following instructions carefully. This manual should be retained for future use.

1.To clean the LCD monitor screen, first, make sure the monitor is in the power off mode. Unplug the monitor from its power source before cleaning it. Do not spray liquid cleaners directly onto the unit. Without applying excessive pressure, clean the screen with a slightly dampened rag.

2.Do not place your LCD monitor near a window. Exposing the monitor to rain, water, moisture, or sunlight can severely damage it.

3.Do not place anything on top of the monitor-to-PC signal cord. Make sure the cord is placed in an area where it will not be stepped on.

4.Do not apply pressure to the LCD screen. Excessive pressure may cause permanent damage to the display.

5.Do not remove the cover or attempt to service this unit by yourself. You may void the warranty. Servicing of any nature should be performed only by an authorized technician.

6.Safe storage of the LCD monitor is in a range of minus 20 to plus 60 degrees Celsius. Storing your LCD monitor outside this range could result in permanent damage.

7.Immediately unplug your monitor and call an authorized technician when:

The power or monitor-to-PC signal cord is frayed or damaged.

Liquid has been spilled into the monitor, or it has been exposed to rain.

The monitor has been dropped or the case has been damaged.

8.Only with use of supplied adaptor, in case of loss or replacement contact the retailer or service center.

9.If you lost the power cord that we given, you must to purchase a same configuration/type of power cord (with ground-connection)

JapanVCTF type, 3 wires or with ground-wire, T-mark approval is required.

U.S.VW-1; 18AWG X 3C; SVT with national approval as UL and/or CSA approval/number(s)

EuropeVDE/ÖVE and/or KEMA approval; H05VV-F, 3G, 0.75mm2, or equivalent.

Above power cord should bear with the type and manufacturer name on.

iii

Image 5
Contents Operating Instructions Page Preface Radio Frequency Interference Statement Important Operating Instructions Introduction Standard Item UnpackingLCD Multimedia Monitor Front View Identifying ComponentsTilting the Monitor Adjusting the Tilting AnglePage Power Management System LCD Multimedia Monitor Control Panel Display ControlsMONITOR-CONTROL Option Adjusting the Monitor’s DisplayOSD-CONTROL Option MISC-CONTROL Option GRAPHIC-CONTROL OptionOSD Exit Option Digital Mode OptionalOSD-CONTROL Option Video or S-VIDEO Mode VIDEO-CONTROL Option MISC-CONTROL Option No Video Auto-adjusthot-key button Hot-Key Buttons for Quick Adjustment of MonitorTroubleshooting Procedures TroubleshootingProblem There is no Video Signal Technical Information LCD Monitor SpecificationsRelative Humidity Altitude 0-12,192m Supported Timing Tatung Company of America