Vidikron VL-40 manual 4Operation, Turning on the Power, Changing the OSD Language

4Operation

1.Turn on your source components.

2.Plug the female end of the supplied power cord into the AC receptacle on the rear of the DView (AC 100V ~ 240V). See Figure 2-2.

3.Connect the other end to your AC power source.

4.Turn on the main power switch at the rear of the display. The power indicator lights red to indicate that the DView is in “standby” mode.

4.1

Turning on the Power

5.Press the ON button on the remote control to turn on the display (or press the power button on the side of the display). The power indicator flashes for a few seconds, then lights solid green.

6.After a brief warm-up period (approximately 10 seconds), the DView will display an image.

OFF

1 2

ON

3

4 5 6

7 8 9

The DView OSD language is initially set to English, but can also display the menus in French (Français), Spanish (Español), Portuguese (Português) or German (Deutsch). To change the OSD language:

1.Press MENU.

2.Select Setup from the Main Menu.

3.Select OSD Language from the Setup Menu.

4.Press or to highlight the desired language and press ENTER. The change takes effect immediately.

4.2

Changing the OSD Language

Vidikron VL-40 and VL-46 Owner’s Operating Manual 25