Infrared remote control wiring | Stewart Filmscreen Corp C manual

Installing the infrared remote control option

The optional Stewart Filmscreen infrared remote control allows control of the screens from anywhere in the room.

Note: The distance between the hand-held remote control and the receiver can be up to 50 feet. It is necessary to have uninterrupted line-of-sight between the remote and the receiver.

Preparing the connection

Before making the electrical connections, you need:

An available 120V AC constant power source

A 4-conductor switch hook-up cable (4-conductor bell wire or category 5 cable is typically used for long runs)

Making the connection

Refer to the diagram that is located on the white label inside the steel housing, and in Figure 11.

1.Mount the low-voltage control box near the screen.

2.Mount the infrared (IR) eye sensor near the screen.

3.Connect the low-voltage control box to the screen by connecting the screen motor power leads to the power strip terminal block located on the circuit board of the control box.

4.Connect the IR eye sensor to the small black plug in module located next to the switch input on the circuit board.

5.Connect the low voltage control box to the 120V AC power source by connecting the AC line voltage to the power strip terminal block located on the circuit board of the control box.

6.Connect the switch to the low-voltage control box.

Infrared Sensor

120V AC

Line

Neutral

COMMON-White

UP-Red

DOWN-Black

R/F Input

InfraRed Input

Low Voltage Switching

Infrared Remote Control

STOP-Yellow

COMMON-White

UP-Red

DOWN-Black

Low Voltage Control Box

4 Conductor Hook-up Cable - 20ga Minimum Category 5 recommended (NOT Supplied)

Figure 11: Infrared remote control wiring

3-Button

Momentary Switch

Luxus A/SR-1 Electriscreen: Owner’s Manual