Output Polarity
If set to “Norm” output polarity is the same as input polarity, if set to “Inv” the output polarity is inverted. This can be used to correct polarity errors in the input signals fed to the card.
Tone Frequency
This sets the frequency of the test tone for each of the four tone generators. Each of the four tone generators TG1 – TG4 can be set to a different frequency, and are available as audio sources for the embedded or AES audio outputs. The tones can range from 50Hz to 16kHz.
Display Submenu
Menu Structure | Parameter Type | |
Disp | H/V | Display Orientation |
| BRGT | Display Brightness |
Display Orientation
This parameter lets you change the orientation of the display. “Vert” makes the characters look correct when the cards are mounted in a 2 RU frame like the 8310. “Horz” makes the characters look right in a horizontal frame.
Display Brightness
This parameter allows you to set the standard output brightness of the menu display. It is a percentage of maximum brightness.
Preset Submenu
MENU STRUCTURE | Parameter Type | |
Prst | Slct | Select Preset |
| Save | Save Settings |
| Load | Load Settings |
| Fact | Restore Factory Settings |
Select Preset
Select from one of the five saved presets.
Save Settings
In this parameter, move the toggle switch up to save the settings to the card persistent storage.
Load Settings
In this parameter, move the toggle switch up to load the saved settings and make them active.
Restore Factory Settings
In this parameter, move the toggle switch up to make the factory default settings active, and make the stored settings equal to the factory settings.
Page 18 of 28 | 9323 Owner’s Manual • (V 2.1) |