Daewoo DSL-17W1T TV/AV/PC Mode Selection, SUB Jack PC RGB, AV Input Jack AV1, Headphone Jack

DSL-15D1T PAL(‡» ˙ )GB 03.10.22 5:5 PM ˘ ` 10 mac001 1200DPI 80LPI

Preparation

Preparation

TV/AV/PC MODE SELECTION

Press the AV( ) button on the control panel repeatedly to select the source,

TV AV1(or AV1/S-video) Component AV2(or AV2/RGB) PC TV

You can select the source direct using the TV, AV, COMP, PC button on the remote controller. Press the AV button on the remote controller repeatedly to select AV1 or AV2. In AV mode, you can change the TV programme number with the UP/DOWN button or the NUMBER button.

NOTE : When the TV SET is no signal, OSD(On Screen Display) appears on the screen.

TV

PAL 50Hz/4.43MHz

D-SUB JACK (PC RGB)

This jack has RGB inputs and is used to connect a PC.

Display mode

If the signal from the PC system equals one of the standard

signal modes, the screen will automatically adjust and display image. If the signal from the PC system doesn’t equal any of the modes, adjust the Video card setting on the computer. For the display modes listed below, the screen image has been optimized during manufacture. The message “Out Of Range” will appear when the PC signal does not correspond to any of the below standard setting.

ENGLISH

PC

1024X768 / 60Hz

AV INPUT JACK (AV1)

This jack has video / audio inputs.

It is used to connect a VCR, Camcorder, DVD, STB, Video game.

S-VIDEO INPUT JACK (AV1/S-VIDEO)

It has Y/C inputs. This jack is used to connect S-Video equipment. NOTE: The AV Audio input Jack and S-video Audio input Jack are shared connections. So, you can not connect both the AV Audio Input cable and S-video Audio Input cable. When the S-video Jack is connected, the TV set switches automatically to AV1/S-videomode.

COMPONENT INPUT JACK (COMPONENT)

This jack has Y/Pb(Cb)/Pr(Cr) inputs and audio inputs.

It is used to connect a DVD.

SCART JACK (AV2, AV2/RGB)

This jack has video / audio inputs and outputs, RGB inputs. It is used to connect a STB, VCR, DVD.

When the signal is RGB, the TV set switches automatically to AV2/RGB mode.

In most cases, the TV set switches automatically to AV2(or AV2/RGB) mode, when the external equipment connected is in playback mode. If not, then use the AV button to select AV2(or AV2/RGB).

HEADPHONE JACK

Insert the headphone plug(3.5 mm ø) into this jack( ). The sound from the speaker will be automatically cut off.

You can control the headphone sound with the LEFT/RIGHT button.

AV1

PAL 50Hz/4.43MHz

AV1/S-video

PAL 50Hz/4.43MHz

Component

YUV 50Hz

AV2

PAL 50Hz/4.43MHz

Standard	Resolution(Mode)	V-frequency (Hz)	H-frequency(kHz)
MAC	640x480	60	31.47
		66	35.00
	832x624	75	49.73
	1024x768	60	48.78
		75	60.24
IBM	640x350	70	31.47
	640x480	60	31.47
	720x400	70	31.47
VESA	640x350	85	37.86
	640x400	85	37.86
	640x480(VGA)	72	37.86
		75	37.50
		85	43.27
	720x400	85	37.93
	800x600(SVGA)	56	35.16
		60	37.88
		72	48.08
		75	46.88
		85	53.67
	1024x768(XGA)	60	48.37
		70	56.48
		75	60.02
		85	68.68
	1280x768(WXGA-only 17”)	60	47.70

PC AUDIO INPUT JACK

Connect the stereo audio cable to the PC AUDIO jack and the other end to the Audio Out terminal of the Sound card on your PC.

10 11