` 24 mac001 1200DPI 80LPI | |
|
|
Daily Use
PIP (Picture in Picture)
Troubleshooting
Please check the following items before calling for the repair services.
ENGLISH
In PC mode, you can watch TV or an AV device such as a VCR or DVD a small window
Call up PIP in the Feature menu.
PIP ON/OFF AND PIP SIZE SELECTION
Use this to switch the PIP on or off and select the PIP size among Small, Middle, Large.
You can control with
P i c t u r e | P I P |
|
S o u n d | S i z e |
|
F e a t u r e s | S o u r c e | T V |
S e t u p | P o s i s t i o n |
|
| S o u n d | P C |
Select | Adjust | Exit |
Problem | Check item | Reference page |
TV set |
|
|
Control/System lock up | · The TV may have malfunctioned. | - |
| · Switch your TV off and on again with the main | 16 |
| /OFF button on the TV set. |
|
Remote control does | · Perform control/system lock up reset (as above) |
|
not work. | · Replace the batteries in the remote controller. | 6 |
| · Make sure the Remote sensor window is not | - |
| under strong light e.g. a fluorescent lamps. |
|
Local buttons do not work. | · Has the Child lock been switched on? | 20 |
No picture and no sound. | · Check that the TV set is switched on at the main /OFF switch. | 16 |
No picture. | · Make sure the brightness and contrast are not set to minimum. | 17 |
No colour | · Make sure the Colour is not set to minimum. | 17 |
PIP SOURCE SELECTION
Use this to select the PIP input signal among TV, AV1
You can select the PIP input signal with
When PIP input is TV, you can select a TV program with UP/DOWN button.
NOTE: Component source only works in 576i, 480i signal.
The 576p, 480p, 720p, 1080i signals are not available.
PIP POSITION SELECTION
Use this to select the picture position among
You can select the picture position with
SOUND OUTPUT SELECTION IN PIP MODE
Use this to select the output sound, PC or PIP (TV, AV, Component) for the loudspeakers or headphone in PIP mode.
You can select the sound output source with
| · Check the Colour standard settings. | 15 | |
Picture is too light or too dark. | · Adjust the Brightness, Contrast. | 17 | |
The picture is improperly tinted. | · Adjust the Colour temperature. | 20 | |
| · Check the Tint adjustment (NTSC signal) | 17 | |
No sound. | · Check that the volume is not set to minimum. | 19 | |
| · Check sound is not muted. | 19 | |
| · Make sure headphones are not connected. | 10 | |
Aerial |
|
|
|
The picture is not sharp. | · Reception may be weak. |
| |
The picture shakes. | · The quality of the broadcast may also be poor. |
| |
| · Make sure the aerial is facing the correct direction. |
| |
| · Chcek that the outside aerial is not disconnected. |
| |
The picture is ghosted. | · Mountains or high buildings can cause double pictures. |
| |
| · Try changing the direction of the aerial. |
| |
The picture is spotted(snow). | · There may be interference from automobiles, trains, high voltage | ||
| lines, neon lights, etc. |
| |
| · There may be interference between the aerial cable and power cable. | ||
| Try positioning cables further apart. |
| |
Picture has lines and faded colours. | · Transmission aerial of amateur radios and cellular phones may |
| |
| cause interference. |
| |
| · Position the TV set as far away as possible from devices that may | ||
| cause interference. |
| |
PC |
|
|
|
Poor image | · Adjust the Phase and Frequency. |
| 23 |
Image is not centered on screen | · Adjust the Horizontal and vertical position. |
| 23 |
24 | 25 |