Daewoo SD-2100P Connections and Copying, TotheTVviaantennacableifyouarenotusing a SCART cable

DV6T711P-AP(DESUK)2 02.7.22 3:45 PM ˘ ` 44 mac001 300DPI 120LPI

Connections and Copying

■If you are using a SCART cable, select the AV input on the TV to see the picture from the player.

■If you are not using a SCART cable, select the button number on the TV reserved for video input to see the picture from the player.

TotheTVviaantennacable(ifyouarenotusing a SCART cable)

If you are not using a SCART cable, your player can transmit pictures and sound to the TV via the coax aerial cable. Just tune the TV to the player's transmitting channel (factory set to UHF CH 52). Tune the TV carefully to ensure the best pictures and sound.

1 Once you have carried out the steps in "Connecting up the player" , switch on your TV.

Press the [OK] button of the player’s remote control longer than 5 seconds to call the player´s test picture.

Tune the TV to the test picture using the channel pre- set functions of your TV as described in its manual. When you have found the test picture, store it under the button number on your TV for player input. Press the [OK] button of the player’s remote control again longer than 5 seconds to release the test picture.

2	• If the quality of the test picture transmitted to the TV is
	poor due to interference caused by a station
	transmitting on channel 52, you can tune the player to
	a different transmitting channel. Find a free channel
	between 21 and 69 on your TV.
	Call the player’s "MAIN SETUP" choose
	"VCR SETUP" then "RF OUTPUT SET".

Type in the free channel.

Store and exit.

CHECK UP!

RF OUTPUT SET

CH52

0-9:SELECT (21-69)

OK:CONFIRM SETUP:END

•If the quality of the test picture transmitted to the TV is poor, fine-tuning on the TV may help (refer to the TV manual).

•Without a scart cable, you will not get stereo sound from a TV capable of stereo sound.

44