COBY electronic DTV-102 specifications Installation, Setup Checklist, Unpacking, Cabel Connections

Page 5

Installation

2.1 Setup Checklist

The required hardware and equipment necessary to use the DTV-102 are:

-DTV-102 converter box

-Converter box remote control and 2 AAA batteries

-RF cable for output

-Composite video and audio cables, or RF cable, for output

-RF video source (terrestrial antenna)

-Analog TV with composite video/audio or RF input

2.2Unpacking

The following items are included with your product. If any items are missing, contact your dealer.

Main Unit

Remote

RCA Cable

RF Cable

Installation

2.3 Cabel Connections

Figure 4. Cable Connections

AB

To Wall Outlet

MONITOR WITH AV /RF INPUT

NOTE: Set the external receiver to the relative input mode to enable the signal pass. When output signal, refer to the user’s manual of the external receiver as well.

Input the TV signal to your converter box

Connect the RF source to the RF IN connector located on the unit’s rear panel. To view television channels, a

signal must be received by the device from one of the following sources: The internal antenna/An outdoor aerial

antenna/A cable television network/A satellite network.

RF IN

- 7 -

- 8 -

Image 5
Contents DTV-102 Introduction Safety and Product InformationImportant Safety Instruction Board Level Description ConnectorsPower Indicator Remote Control Description Key DescriptionRF Signal RF Signal OutSetup Checklist InstallationInput the TV signal to your converter box UnpackingPower Connection Remote Control Battery InstallationChanging Channels Basic OperationInitial Channel Scan Audio and Language Control Volume ControlAudio Channel Information Menu LanguageClosed Caption Guide DisplayManual Scan Channel Menu FeaturesMenu Operation Channel Add Option Menu FeaturesSee the Figure Aspect RatioAudio Language Standard Off DCC View Sleep ModeLock Menu Features Block Channel Lock SystemTV Rating-General TV Rating GeneralDownloadable RRT Movie RatingReference