
Installation
Output the TV signal from your converter box to the external receiver
You can adopt either of the methods below to output the TV signal to the external monitor. Refer to A,B in the Figure 4. for better understanding.
A. CVBS Output
Connect the video port (VIDEO) by the supplied RCA cable. (yellow plug). Connect the audio port (L, R) by the supplied RCA cable (white&red plug).
B. RF Output
Connect the RF OUT port by the RF cable to output the TV signal.
NOTE: Only two channels are available if you chose to output the signal by the RF cable.
Slide the channel switch on the unit’s rear panel to select the channel 3 or the channel 4. Left Position - - CH3 Right Position - - CH4
C. Analog
-Power On : User Setting the A/V and Modulator 3/4Ch Output
-Power Off : User Setting the analog
Installation
2.4 Remote Control Battery Installation
1.Unlatch the battery compartment cover on the back of the remote control.
2.Insert 2 AAA batteries into the battery compartment, making sure the + and – ends of each battery line up with the corresponding marks in the battery compartment, as shown in Figure 5 below.
3.Snap the cover back on to the remote control.
1) Power On Application
Analog Signal
Digital Signal
Ant In | MD 3/4Ch |
Composite Video Output Audio L/R
Figure 5. Install Remote Control Batteries
2.5 Initial Setup
After the input/output connections have been made, and the
ANT IN ANT OUT |
2) Power Off Application
|
|
|
|
|
|
| Receive the Analog Signal |
Analog Signal |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Digital Signal | Ant In |
| |||||
|
|
|
|
|
| Signal |
|
|
|
|
|
|
|
|
|
|
|
| ANT IN | ANT OUT |
Power Connection
Insert the power plug into the wall outlet with
NOTE: Be sure to have all necessary cable connections properly done before connect the power source.
If the player will not be used for a long period of time, disconnect the power and remove the batteries from the remote.
display. Refer to Chapter 4 for more details about all of the Menu features and controls.
Figure 6. Main Menu
- 9 - | - 10 - |
|