Front Panel Operations (Remote
Tuning preset stations (Preset Tuning)
1Turn FUNCTION to display “TUNER”.
2Press SHIFT to select a memory page (A, B or C).
3Press PRESET TUNING + or – repeatedly to select the station you want. Each time you press the buttons, the preset numbers change as follows:
nA1÷A2÷...A9÷A0÷B1÷B2÷...B9÷B0N
nC0÷C9...C2÷C1N
Note
Recording
For the
1Turn FUNCTION to select the playback component you want to record.
2Insert a blank tape into the recording component and adjust the recording level, if necessary.
3Start recording on the recording component, then start playing the playback component.
If the AC power cord is disconnected for about 1 week, the
preset stations will be cleared. Preset the stations again.
To stop recording
Stop both components.
Replacing audio while recording a video component (Front panel only)
1 Follow steps 1 to 3 of “Playing audio and video components at the same time” on page 49.
2 Insert a blank video tape into the recording VCR.
3 Start recording on the recording VCR, then start playing both the video and audio components you want to record.
To change the video component in step 3
Press MODE to display “V: ....” (VISUAL MODE) and select
the other video component within 8 seconds.
To record other audio on a specific part of video
1 Pause the video component at the point where you want to record the other audio.
2 Press MODE to display “A: ....” (AUDIO MODE),
then select the audio component you want.
3 Start recording on the recording VCR, release the pause mode and start playing the audio component. To resume recording the original sound, press MODE to display “A: ....” (AUDIO MODE) and
select the original source.
(continued)
51