APPENDIX
TROUBLESHOOTING
Before calling your dealer or service center for assistance, check the matters below once again.
1.Make sure you have connected LCD TV to your equipment as described in the section "CONNECTING LCD TV".
2.Check cable connection. Verify that all external equipment and power cords are properly connected.
3.Verify that all power is switched on.
4.If LCD TV still does not produce an image,
5.If the image still does not appear, unplug LCD TV from the external equipment and check the external equipment. The problem may be with your graphics controller rather than with LCD TV. (When you reconnect LCD TV, remember to turn the external equipment and TV off before you power up LCD TV. Power
the equipment back on in order of : LCD TV and external equipment.)
6.If the problem still exists, check the following chart.
Problem: | Try these Solutions | |
|
| |
NO | ● Plug this LCD TV into the AC outlet. | |
● Press | ||
| ||
POWER | ● Check POWER Indicator. If this indicator flashes, LCD TV has any trouble. | |
Remote | ● Check the batteries. | |
● Make sure nothing is between the Remote Receiver and the Remote Control. | ||
Control | ||
● Make sure you are not too far from LCD TV when using Remote Control. | ||
does not | Maximum operating range is 16.4' (5m). | |
● Is direct sunlight or strong artificial light shining on LCD TV's Infrared Remote | ||
work | ||
Receiver? Eliminate the light by closing curtains, pointing the light in a different | ||
| direction, etc. | |
No image | ● Check the connection between the external equipment and LCD TV. | |
● When turning LCD TV on, it takes a few seconds to display the image. | ||
| ||
| ● Check the system that you select is corresponding with the external equipment or the video | |
| equipment. | |
| ● Make sure the temperature is not out of the Operating Temperature (0°C ~ 40°C). | |
| ● Turn off power, then turn on again, | |
No sound | ● Check Audio cable connection from Audio input source. | |
● Adjust the Audio source. | ||
| ||
| ● Press VOLUME (+) button. | |
| ● Press MUTE button. | |
There are |
| |
tiny black |
| |
points | ● Dark or bright points of light (red, green, or blue) may appear on the screen. This is a | |
and/or | ||
characteristic of the LCD panels, not a malfunction of the LCD TV. | ||
bright | ||
| ||
point on |
| |
the TV |
| |
Abnormal | ● Adjust the value of colour. | |
colour of | ● Select different colour system. | |
image | ||
| ||
|
|
WARNING :
High voltages are used to operate this LCD TV. Do not attempt to open the cabinet.
If the problem still persists after following all operating instructions, contact the sales dealer where you purchased LCD TV or the service center. Give the model number and explain the difficulty. We will advise you how to obtain service.
17