|
|
|
|
| CAUTION |
| THIS SYMBOL INDICATES THAT DANGEROUS VOLTAGE CONSTITUTING A |
|
|
| |
|
|
| RISK OF ELECTRIC SHOCK IS PRESENT WITHIN THIS UNIT. |
| RISK OF ELECTRIC SHOCK DO NOT OPEN! | ||
|
|
| |
|
|
|
|
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR |
| THIS SYMBOL INDICATES THAT THERE ARE IMPORTANT OPERATING AND | |
BACK). NO |
| MAINTENANCE INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THIS | |
VICE PERSONNEL. |
| UNIT. | |
|
|
|
|
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT SAFETY INSTRUCTIONS
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna. |
1. | Read these instructions. |
2. | Keep these instructions. |
3. | Heed all warnings. |
4. | Follow all instructions. |
5. | Do not use this apparatus near water. |
6. | Clean only with dry cloth. |
7. | Do not block any ventilation openings. Install in accordance |
| with the manufacturer’s instructions. |
15. If an outside antenna is connected to the television equipment, |
be sure the antenna system is grounded so as to provide some |
protection against voltage surges and built up static charges. In |
the U.S. Selection |
provides information with respect to proper grounding of the |
mast and supporting structure, grounding of the |
an antenna discharge unit, size of grounding conductors, |
location of antenna discharge unit, connection to grounding |
electrodes, and requirements for the grounding electrodes. |
– Increase the separation between the equipment and receiver. |
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. |
– Consult the dealer or an experienced radio/TV technician for help. |
CAUTION: FCC Regulations state that improper modifications or unauthorized changes to this unit may void the user’s authority to operate the unit.
8. Do not install near any heat sources such as radiators, heat |
registers, stoves, or other apparatus (including amplifiers) that |
produce heat. |
9. Do not defeat the safety purpose of the polarized or grounding- |
type plug. A polarized plug has two blades with one wider than |
the other. A |
grounding prong. The wide blade or the third prong are provided |
for your safety. If the provided plug does not fit fully into your out- |
let, consult an electrician for replacement of the obsolete outlet. |
10. Protect the power cord from being walked on or pinched |
particularly at plugs, convenience receptacles, and the point |
where they exit from the apparatus. |
11. Only use attachments/accessories specified by the |
manufacturer. |
16. An outside antenna system should not be located in the vicini- |
ty of overhead power lines or other electrical light or power |
circuits, or where it can fall into such power lines or circuits. |
When installing an outside antenna system, extreme care |
should be taken to keep from touching such power lines or |
circuits as contact with them might be fatal. |
EXAMPLE OF ANTENNA GROUNDING ACCORDING
TO NATIONAL ELECTRICAL CODE, ANSI/NFPA 70
TRADEMARKS
Manufactured under license from Dolby Laboratories. “Dolby” is a trademark of Dolby Laboratories.
HDMI, the HDMI Logo and
“As an Energy Star® Partner, Sanyo Manufacturing Corporation has deter- mined that this product meets the Energy
SANYO recommends keeping the TV set at its factory settings or moving Energy Saver settings from “Off” to “Low” or “High” to further reduce power requirements and increase energy savings. Doing so contributes to the sustainability of our resources and environment.
For more information visit www.energystar.gov
12.Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from
13.Unplug this apparatus during lightning storms or when unused for long periods of time.
14.Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
“Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article
17.Wall or Ceiling
18.Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on the apparatus.
19.When the MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.
Star® guidelines for energy efficiency.”
This symbol on the nameplate means the product is Listed by Underwriter’s Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.
CONTAINS MERCURY LAMPS, DISPOSE OF PROPERLY
2 | Need help? | www.sanyoctv.com | Need help? | www.sanyoctv.com | 3 |