Sanyo LCD-42E3, LCD-32E3, LCD-19E3, LCD-26E3 manual Signal Mode Column recommended

SIGNAL MODE COLUMN (recommended)

This LCD TV can correspond to the signals below. After connecting with the computer, LCD TV can automatically recognize the signal from the connected PC (computer) / HDMI.

PC SIGNAL MODE COLUMN (recommended)®

19” / 26” / 32” / 42”

SYSTEM MODE	Resolution	V-Freq.(Hz)	H-Freq.(KHz)	PIXELS CLOCK (MHz)
VGA	640x480	59.94	31.47	25.18
SVGA	800x600	60	37.88	40
XGA	1024x768	60	48.36	65
WXGA	1360x768	60	47.712	85.5
WXGA	1280x768	60	47.78	79.5
SXGA	1280x1024	60	63.981	108
(42" Full-HD only)

NOTE:

■■ In case LCD TV can not display properly due to the connecting cable or the graphic hardware, please make adjustments about phase, clock and soon.

■■ In principle, LCD TV can not display the signal mode which not described in the above column. But sometimes it can display a signal very similar with one of the signal described.

■■ If you want to change the definition and color of PC, please select one from the column.

■■ It is not the trouble of LCD TV if interference appears on the picture while switching the signal mode. ■■ The Dot Clock of the computer’s signal must be less than 108 MHz.

■■ Specifications are subject to change without notice.

■■ When the input signal from PC is out of above PC signal mode column, “No Support” caution message will display. But in some case, the LCD TV still display the PC signal though the signal mode doesn’t exist on above list. Under this condition, the display position may not correct and quality may not be admitted also.

When input signal is digital from HDMI terminal, refer to the chart below.

19” / 26” / 32” / 42”

SYSTEM MODE	Resolution	V-Freq.(Hz)	H-Freq.(KHz)	PIXELS CLOCK (MHz)
480I	720(1440)x480	59.94	15.73	27
480P	720x480	59.94	31.47	27
720P/60	1280x720	60	45	74.25
1080I/60	1920x1080	60	33.75	74.25
1080P/24	1920x1080	24	26.973	74.25
(42" Full-HD only)
1080P/60	1920x1080	60	67.5	148.5
(42" Full-HD only)

26