Dish Network 6.3 manual Control Amplifier Volume, Control TV Volume

Control Amplifier Volume

7Press the plus (+) and minus (-) sides of the VOL- UME button.

8The equipment’s volume changes and the AUX mode

button lights instead of the TV mode button.

Control TV Volume

7Press the plus (+) and minus (-) sides of the VOL- UME button.

8The TV’s volume changes and the TV mode button lights instead of the AUX mode button

PROGRAMMING THE REMOTE TO CONTROL A SECOND RECEIVER IN AUX MODE

If you have another DISH Network satellite receiver installed, you can use this remote in AUX mode to control it along with your new receiver. When you program the remote to control the other receiver, the remote will send out IR and UHF (not UHF Pro) signals to the receiver. You can program the remote to control any other DISH Network satellite receiver, except for following:

•TV2 on DISH 322, DISH Player-DVR models 522, 625, 942 and ViP222 & ViP622 DVR

•DishPlayer 7100/7200

1Turn on the other receiver and display the System Info screen (see the receiver user’s guide for information on how to display the screen).

Write down the address shown:

2Press and hold the AUX button until all the other mode buttons light up, and then let go of the button. The AUX button flashes.

3Press the 3 button.

4Use the NUMBER PAD to enter the address you wrote in step 1.

5Press POUND (#). The AUX button blinks three times.

6Press RECORD to make sure the address and the remote matches the address on the receiver.

7