Installation
Projector/DHD Controller: Plug the female end of one power cord into the AC | Connecting to AC Power | |
receptacle on the rear of the |
| |
your AC power source. |
| |
Similarly connect the DHD Controller to a nearby AC outlet. |
| |
AutoScope Lens Motor: With |
| |
cord is provided for the lens motor. Plug the female end of the AC power cord into the AC |
| |
input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power |
| |
source. |
|
|
Caution | The input voltage to the AutoScope lens motor must be between |
|
100 and 120 VAC. Do not connect the AutoScope lens motor |
| |
to a
1.Turn on your source components.
2.Turn on the main power switch at the rear of the projector.
3.Turn on the main power switch at the rear of the DHD Controller.
4.If this is an
5.Press the ON button on the remote control – or the POWER button on the DHD Controller front panel – to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”
6.When the projector is ready for use, the fluorescent display indicates the active source, input resolution/frame rate and aspect ratio; for example:
Current
Source
3.7
Turning on the Power
| HDMI 1 | ||||||
16:9 |
| 1080i/60 | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
Aspect Ratio | Input Resolution/Frame Rate | ||||||
Runco | 39 |