Alloy Computer Products POE120 Series manual Model, 100Mbps Fibre Transceiver

1. Overview

The POE120 Series IEEE 802.3u compliant media converters support two types of media 10/100 Base-TX and 100Base-FX. With LFP (Link Fault Propagation) support it allows the administrator to easily diagnose link faults on their network. If the Copper or Fibre link fails, the converter forces the link status of the connecting device to also fail.

The POE120 Series media converters are fully compliant to the IEEE 802.3af standard. The converters advanced auto-sensing algorithm allows the unit to draw power from any IEEE 802.3af Power Sourcing Equipment (PSE) device (POE100 Series Converter, or PoE Switch) or Power over Ethernet Injector. It also supports high levels of safety support with short circuit protection and power-in auto-detection. The POE120 series converters can be powered from either a standard plug pack or a PSE device.

2. Model Description

	Model		Power Description
POE120 Series		60mA@-48VDC over Cat.5
100Mbps Fibre Transceiver				Wavelength
ST/SC Multimode 2Km				1310nm
SC.S05/S20/S40/S60Km Single Mode				1310nm
SC.S80/S100Km Single Mode				1550nm
Single Fibre Model		TX, RX Wavelength
1310nm Single Mode 20Km		TX (Transmit) 1310nm
		RX (Receive) 1550nm
1550nm Single Mode 20Km		TX (Transmit) 1550nm
		RX (Receive) 1310nm

Note:

The 1310nm and 1550nm models must be installed in pairs,

i.e., install 1310nm model at one end and the 1550nm model at the other end.

3. Checklist

Before you start installing the POE converter, please verify that the package contains the following items.

-The POE120 Series Converter

-CD containing this manual

Please notify your sales representative if any of the above items are missing or damaged.