Accton Technology EC3802-WDM manual Desktop Mounting, Mounting the CPE

Installing the FTTH CPE

Mounting the CPE

Caution: The EC3802-WDM CPE is for indoor mounting only. Do not mount the unit on the outside of a building.

The CPE includes rubber feet for desktop mounting.

Before you start installing the CPE, make sure you can provide the right operating environment. Verify the following installation requirements:

•Power requirements: 12 VDC via the attached AC power adapter. Make sure that a properly grounded power outlet is within 1.8 m (6 ft) of the CPE.

•The CPE should be located in a cool dry place, with at least 5 cm (2 in.) of space on all sides for proper air flow.

•Place the CPE out of direct sunlight, and away from heat sources or areas with a high amount of electromagnetic interference. The temperature and humidity should be within the ranges listed in the specifications.

•Make sure the fiber line is carefully routed to the CPE in a way that does not incur a bending radius in the cable of less than 30 mm.

•Be sure that the CPE is accessible for the UTP Ethernet connection.

•Make sure UTP cable is routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference such as radios, transmitters, etc.

•The status LEDs are clearly visible.

18