Connections Connecting to Optional Equipment

Connections (Continued)

Connecting to Optional Equipment

Connecting to an amplifier equipped with two channel analog stereo or Dolby Surround

Connect the Left and Right AUDIO OUT jacks on the DVD Player to the audio left and right in jacks on your amplifier, receiver or stereo system, using the supplied audio cables (A).

Connecting to an amplifier equipped with two channel digital stereo (PCM) or to an Audio/ Video receiver equipped with a multi-channel decoder (Dolby Digital™, MPEG 2 or DTS)

1OUT jack (COAXIAL X) to the corresponding in jack

on your amplifier. Use a digital (coaxial X) audio cable.Connect one of the DVD Player’s DIGITAL AUDIO

You will need to activate the player’s digital output.

2 (See “Digital Audio Output” on page 14).

Digital Multi-channel sound

A digital multi-channel connection provides the best sound quality. For this you need a multi-channel Audio/Video receiver that supports one or more of the audio formats supported by your DVD Player (MPEG 2, Dolby Digital and DTS). Check the receiver manual and the logos on the front of the receiver.

otes

–If the audio format of the digital output does not match the capabilities of your receiver, the receiver will produce a strong, distorted sound or no sound at all.

–Six Channel Digital Surround Sound can only be obtained if your receiver is equipped with a Digital Multi-channel surround sound decoder.

–To confirm the audio format of the current DVD selection display, press AUDIO.

–Repeated pressing of the AUDIO button may allow you to select between various audio formats available on the disc.

Rear of DVD player

PREPARATION

X		A
X		A

COAXIAL	L	R
DIGITAL INPUT	AUDIO INPUT

Amplifier (Receiver)

ote

This player does not perform internal (2 channel) decoding of a DTS sound track. To enjoy DTS

multi channel surround, you must connect this player to a DTS compatible receiver via one of this player’s digital audio outputs.