ZyXEL Communications MC100FX-SC2/30 manual Applications, Application Diagram

Page 14

MC100FX-SC2/30-A User’s Guide

Chapter 2

Applications

To effectively expand a Fast Ethernet network, position two converters back-to-back as illustrated.

Application Diagram I

In the next figure, the converter is functioning as a high-speed bridge between switches, creating increased capacity for each user (node) on the local area network.

Switch ↔ CONVERTER ↔ CONVERTER ↔ Switch

Multi-mode 2Km

Single Mode 30Km

Application Diagram II

In the next figure, the converter is functioning as a server aggregation for an enterprise configuration. It is providing a 100Mbps full-duplex link to workgroups of 10/100 switches located on separate floors within a single building.

Switch ↔ CONVERTER ↔ CONVERTER ↔ Server

3

Image 14
Contents User’s Guide Disclaimer FCC Warning CE Mark WarningSafety Warnings Iii Viewing Certifications RegistrationTable of Contents Costa Rica Required InformationCorporate Headquarters Worldwide Czech RepublicFrance DenmarkFinland GermanyNorway KazakhstanNorth America PolandSweden RussiaSpain UkraineMC100FX-SC2/30-A User’s Guide Introduction Key Features Application Diagram ApplicationsMC100FX-SC2/30-A User’s Guide Hardware Front Panel100Base-FX port LED Indicators100Base-TX port Link Fault Signaling Rear PanelDIP Switches Loop-back TestingTest Condition Local Loop-backRemote Loop-back NWay DIP-switch Setting MC100FX-SC2/30-A User’s Guide Specifications SpecificationFDX/COL TroubleshootingLNK/ACT Check the fiber cable connection between the media converter