ZyXEL Communications MC100FX-SC2/30 manual Local Loop-back, Remote Loop-back, Test Condition

MC100FX-SC2/30-A User’s Guide

Make sure that the cables are connected properly before getting started. Conduct either the local or remote test, not both at the same time. Follow the steps below to perform the diagnostic tests.

Local Loop-back

1.Test Condition set-up – for an accurate result, be sure to set the DIP switches according to the table below:

Test Condition

DIP Switches	1	2	3	4	5	6	7
Converter A	OFF	FD	100	FD	OFF	ON	OFF
Converter B	OFF	FD	100	FD	OFF	OFF	OFF

2.Launch a loop-back or diagnostics testing program and follow the instructions given. Typically, the instructions will be similar to the following:

zEnter the number of test messages (frame packets) to be sent (between 1 and 1000).

zClick on the START button.

zThe program will send a testing message that will loop in the copper segment – it will then display a pass/fail result.

Remote Loop-back

1.Test Condition set-up – to produce an accurate result, set switches according to the table

below:

Test Condition

DIP Switches	1	2	3	4	5	6	7
Converter A	OFF	FD	100	FD	OFF	OFF	OFF
Converter B	OFF	FD	100	FD	OFF	OFF	ON

9