Programming
Programming
The following sections list Axcess programming commands used with the
Channel Settings Commands
Use the
AXB-VOL3 Channel Setting Commands
Channel | Description | Channel | Description |
|
|
|
|
1 | Ramps channels 1 and 2 up. | 7 | Ramps channel 2 up. |
|
|
|
|
2 | Ramps channels 1 and 2 down. | 8 | Ramps channel 2 down. |
|
|
|
|
3 | Mutes channels 1 and 2. | 9 | Mutes channel 2. |
|
|
|
|
4 | Ramps channel 1 up. | 10 | Ramps channel 3 up. |
|
|
|
|
5 | Ramps channel 1 down. | 11 | Ramps channel 3 down. |
|
|
|
|
6 | Mutes channel 1. | 12 | Mutes channel 3. |
|
|
|
|
Ramping a volume channel while the mute channel is on will NOT automatically turn off the mute channel (will not restore) but the ramping will still occur and the volume change will be noticed when the mute channel is turned off. For setting ramp rates and presets, see SEND_COMMAND programming instructions below. For reading current volume levels and displaying bargraphs see CREATE_LEVEL and SEND_LEVEL programming instructions. Volume channels 1 through 3 use levels 1 to 3 respectively.
When controlling levels, such as with an active bargraph, there is no LED indication of volume changes.
Levels
1 = Output #1
2 = Output #2
3 = Output #3
5 |
| |
|
|
|