Checking the Codes
If you have set up the remote using the procedure in “Searching for a Code,” you may want to know which
1.On the remote control, press a device key once (TV, CBL/SAT, DVD, VCR or AUD); it blinks once. Then press and hold P until the device key blinks twice.
2.Enter 9 9 0. The device key blinks twice.
3.To find the first digit of the code, press 1 once. Count the number of times the LED blinks and write down the number.
If the LED blinks once, the first digit is 1, if it blinks twice, the first digit is 2, etc. If a code digit is 0, the selected device key does not blink.
4.Repeat step 3 four more times for the remaining digits, pressing 2 to find the second digit, 3 to find the third digit, 4 to find the fourth digit, and 5 to find the fifth digit. Write down the rest of the code and keep it in a safe place.
Volume Lock
Your remote comes preset with the volume locked to the TV mode. This configuration allows you to control the volume of the TV while in the CBL/SAT, DVD or VCR modes.
However, you may change the Volume Lock setting to Global Volume Lock to a different mode so that volume control is always controlled through your audio receiver. After that, you can perform Individual Volume Unlock on a selected device to set its volume control for independent operation.
Locking Volume Control to One Device
1.Press and hold P until the LED blinks twice, then release.
2.Enter 9 9 3. The LED blinks twice.
3.Press the device key for the device you wish to control volume (for example, TV).
The LED blinks twice.
