If YOU have Problems

15-1930.fm Page 10 Monday, July 19, 1999 1:09 PM

MANUAL CODE SEARCH

If the 3-in-One Pocket Remote Control does not op- erate your remote-controlled devices when you first set it up, you might have to manually find the correct code for your devices. You can try all the codes listed in “Manufacturers’ Codes” on Page 12 for the brand of your device, or you can follow these steps to search the remote control’s entire library.

1.Manually turn on the device you want to set up.

2.Press the corresponding device key (TV, VCR, or

CBL).

3.Hold down P until the red light blinks twice, then

press CH three times. The red light blinks twice again.

4.Aim the remote control at the device you want to operate.

5.Repeatedly press PWR then the device key for the device until it responds to the command.

6.When the device responds to the command, press P within 5 seconds to save the code.

Note: If you do not press P within 5 seconds, the remote control does not save the code.

•Because the remote control’s library has so many codes, this procedure can take several minutes.

•If your device turns off during the search, but does not operate after you lock in the code, begin the search again, pausing longer between key presses.

If necessary, repeat these steps for each device.

Need help? Call 1-888-533-7135