Press To Enter This Number | Radio Shack 3-in-One Pocket Remote

15-1930.fm Page 7 Monday, July 19, 1999 1:09 PM

No. 16-421 or 16-422), you must program the TV code for the TV functions and the VCR code for the VCR functions.

2.Press the device key for the type of remote you are replacing (TV, VCR, or CBL). The red light blinks.

3.Hold down P until the red light blinks twice, then enter the 4-digit code using the keys shown here:

Press	To Enter
	This Number

CH	1

VOL	2

VOL	3

CH	4

For example, to replace a TV’s remote control (manufacturer’s code 1433), press TV, hold down P until the red light blinks twice, then press CH , CH , VOL , and VOL .

When the red light blinks twice, the remote con- trol has accepted the code.

Note: If the code you entered is invalid, the red light does not blink.

4.Point the remote control at your device and press PWR Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes listed in “Manufacturers’ Codes” on Page 12 for your brand of TV, VCR, cable converter, or other device.

5.Repeat Steps 2–4 for additional devices.

Need help? Call 1-888-533-7135