•Normal Reboot: when the DVR system reboot without abnormal condition, the system will send out the alarm message.
•Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send out the alarm message.
•Recording is switched off: when the recording has been stopped, the system will send out the alarm message.
•Network is switched off: when the network connection of DVR system is lost, the system will send out the alarm message.
•Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm message.
•Temperature: set a temperature limited of system for system to alarm. When DVR system temperature is over the temperature limited, the system will send out the alarm.
•Illegal Entry: any objects move between selected regions which user has set up in Object Counting section (see Chapter 4.2.1), the system will send out the alarm. Select the entry (object moves from region 1 to 2 or from region 2 to 1) and camera for system alarm detection.
iOnly if camera has been setup in Object Counting will be available for selecting in Illegal Entry.
-Enable/disable the POS Keyword check box, to scan the data from the POS if it matches the keyword (see also Chapter 4.9.11).
-Enable/disable the Alarm Message check box, to active with external alarm message by your own program. For the detail configuration, please contact the local reseller.
6.In (5) Alarm Reset, click the camera number (01 to 16) to set the reset condition of alarm. Once alarm is reset, all alarm action will stop at the moment. If the sensor normal status is high, set the sensor condition to low.
7.In (6) Action, you may now set the alarm action for the system to perform when the alarm condition is activated.
-Launch EMAP
Display mini EMAP screen.
-Call Monitor Out
Switch to only display the video on Call Monitor from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be
66