Venturer KLV39082 manual From previous

Page 12

MOUNTING INSTRUCTIONS

(Continued from previous page)

c)Insert the four selected screws through each hole from the inside of the cabinet going down (see Figure 5).

e)Partially tighten each screw, but do not fully tighten the screws until all of them have been started (see Figure 6).

Figure 5

d)Hold each screw head down and push the unit and spacers onto the screws, then hold the unit up until spacers are firmly against the bottom of the cabinet (and fully nested within each other if you are using multiple spacers for each screw).

Figure 6

f)Gently tighten each screw until they are firmly holding the unit in place. The top front edge of the unit should clear the overhang.

CAUTION

TO REDUCE THE RISK OF FIRE, DO NOT PLACE ANY HEATING OR COOKING APPARATUS BENEATH THIS UNIT.

MOUNTING SUGGESTIONS

1)If your cabinet has obstructions inside it which prevent you from using the template, cut out the corresponding area on the template, but do NOT cut out or through the screw holes.

2)If your cabinet has obstructions underneath it, which will interfere with the mounting of the unit, remove the obstruction before mounting the unit, or find another location to mount the unit.

3)It is recommended that you wear safety glasses while drilling to prevent eye injuries.

4)For wood cabinets, you may want to mark the hole locations with a nail, pressed gently but firmly into the wood so that a slight impression is made. This will also help keep the drill bit centered in the right location.

5)Hold the drill firmly against the cabinet to keep the drill from “walking”.

- 11 -

Image 12
Contents Page Safety Precautions Following marks and symbols are located on back of the unitFCC Information Important Safety Instructions Table of Contents Disc Formats Region Management InformationDisc Function or Operation that is Not Available Icons Used on DVDsAccessories Remote ControlRemote Control Control Reference GuideVOLUME+ Button Adjusts the volume Play Button 24 / Tuning ButtonsSetup Button Function ButtonUnit Mounting Instructions StepFrom previous Connecting the TV Antenna Connecting the Unit to a TV or other Video EquipmentConnecting the AM Loop Antenna and FM Wire Antenna ConnectionsAC power cord To AC outlet Monitor OperationPlugging in the Unit Unit Operation Turning the Unit OnDolby Digital for DVD Setting the Clock Setting the Cooking TimerPausing Playback Still Mode Playing a DiscStopping Playback Skipping to a Different Chapter/TrackAngle Selection Subtitle SelectionAudio Selection Sequence of angle shotsSpecial Function Display FunctionLocating a Specific Title/Chapter/Time Locating a Specific TrackSetting Favorite Bookmarks During Playback Repeat PlaybackDVD Programmable Memory Viewing Jpeg FilesDVD Programmed Playback Play Modes for CD or Jpeg Disc CD Track/JPEG File Programmed PlaybackClear the Programmed Tracks/Files Repeat Off/Single/AllCustomizing the Function Settings LanguageVideo Default View ModeUse Default Settings Smart PictureUsing the TV Atsc TV modeNtsc TV mode Manual Searching for TV ChannelsTV Setup Picture SettingSound Setting TV Timer Setting Misc SettingTime Zone / Day Saving Time / Clock TV Channel Setting Listening to the Radio Troubleshooting Guide Symptom Cause and RemedyMaintenance SpecificationsCleaning the Disc Cleaning the UnitLimited Warranty