Using the TV, Manual Searching for TV Channels

USING THE TV

Connect a TV antenna or CATV cable or Satellite system to the TV antenna terminal before searching TV channels

Searching for TV channels automatically (Only appears to the first time Power ON)

1.Connect the TV antenna.

2.Connect the AC power cord.

3.Press the ON/OFF button to turn on the unit.

4.Press the DVD/TV/RADIO button (the FUNCTION button on the remote) to select TV mode.

5.Press the ENTER button to proceed with auto scan.

6.Use the or button to select “CATV” or “AIR”, then press theENTER button to start auto scan.

7.The unit will immediately search all channels for those with adequate signal strength and store those channels with signals in memory. The unit will take a short minutes to finish auto scan and after this is completed, the unit will switch to the first channel found.

Manual Searching for TV Channels

1.Press the TV MENU button, then press the button to TV CHANNEL SETTING.

2.Press the button to select ANTENNA. Use the or button to select Air or CATV.

3.Use the button to select Auto Scan.

4.Press the ENTER button to enter sub menu of Auto Scan.

5.Use the button to select “Start to Scan” in the sub menu.

6.Press the ENTER button to start the search for TV channels.

7.The screen will show the first received channel when auto search is completed.

Proceed with auto scan?

Please select Antenna type

	RF CH	13
	Found	0

PRESSMENUTO EXIT AUTO SCAN

Watching Television

Viewing a television station after the auto/manual search for channels.

1.Press the FUNCTION button to TV mode.

2.Press the CH buttons (the CH+ or CH- button on the remote) to select a channel, or press the number button on the remote to select the channel you want to watch.

•For channels 1 to 9, enter one-digit channel number.

•For channels 10 to 99, enter the two-digit channel number.

•For channels 100 or over, enter three-digit channel number.

Note:

•When a channel is selected, the channel number is displayed on the top right corner of the screen. This number will disappear after a few seconds.

•When MUTE is pressed, the sound is mute and the “L O” indicator always blinks on the LCD display until MUTE is pressed again or VOL is pressed.

ATSC TV mode:

Press the DISPLAY button, the upper window will pop up, then press the DISPLAY button again, the lower window will pop up. Press the DISPLAY button once to exit.

NTSC TV mode:

Press the DISPLAY button, the upper window will pop up, then press the DISPLAY button once to exit.

- 24 -