Cable Connection
Communication Protocol
Baud rate: | 9600 bps |
Data length: | 8 bits |
Parity: | No parity |
Stop bit: | One bit |
X on/off: | None |
Communications | Full duplex |
procedure: |
|
If the CPU of the LCD projector has received the data correctly, it returns an ACK(C5H). If the received data is not correct, the CPU returns a NAK(CAH), then the following status:
Receiving success: | C5 |
Receiving failure: | CA Err |
Err 01: | Command Error (command not supported) |
Err 02: | Checksum Error |
Err 03: | Busy (command not acceptable) |
Err 04: | Parameter Error ( parameter data abnormal) |
NOTE: If failing in
CA Err 1
Err 1 8X (Apply the corresponding bit.)
Bit 0: Either filter panel or lamp cover is not attached correctly
Bit 1: Fan stoppage
Bit 2: Overheated
Bit 3: Lamp lighting failure
PC Control Connector | To RxD of PC |
▶
| 8 | 7 | 6 |
|
|
| |
5 |
| 4 | 3 |
2
1
To GND of PC
◀
To TxD of PC
▶
