1INTRODUCTION
This section introduces you to your new MultiSync MT830 (SVGA) / 1030 (XGA) LCD Projector, provides a list of materials that comes with your projector and describes the features and controls.
Congratulations On Your Purchase Of The
MultiSync
MT830/1030 LCD Projector
The MultiSync MT830/1030 is one of the very best LCD projectors available today. The multiple LCD panels enable you to project precise images up to 300 inches (762 cm) across (measured diagonally) from your PC or Macintosh computer (desktop or notebook), VCR, DVD player, docu- ment camera, or even a laser disc player.
You can use the projector on a tabletop or cart, you can permanently mount it on a ceiling*1, or you can use MultiSync MT830/1030 LCD Projector to project images from behind the screen. The remote control can be used wirelessly or with a cable, and you can even use the remote control with the
Features you’ll enjoy:
•Simple set up and operation.
•Hot air blown from the vents does not bother the audience during your presentation since the vents are located on the front.
•A
•A wireless remote control that operates the projector from any angle.
•A laser pointer that' s built into the remote control.
•The power zoom control enables you to adjust the image to be between 50.8 and 762 cm (measured diagonally).
•Keystone correction allows you to correct trapezoidal dis- tortion so that the image is square.
•White balance control allows you to adjust the brightness and contrast for each RGB color.
•You can choose between video modes depending on your source: "normal" for a typical picture, "natural" for true color reproduction, and "camera" for use with a document camera or low APL picture.
•The optional MT Viewer kit allows you to start your presentation even when a PC is not available at the site.
•The "image capture" enables you to use the entire picture as a background image or to create slides (optional MT Viewer required).
•An image can be projected from in front or behind a screen, and the projector can even be installed on the ceiling.
•NEC Technologies' exclusive AccuBlend intelligent pixel blending technology - an extremely accurate image com- pression technology - offers a crisp image with SXGA (1280×1024) resolution*3. You can select any point on the screen with the pointer and enlarge the selected area.
•Supports most IBM VGA, SVGA, XGA, SXGA(with AccuBlend)*3, Macintosh, or any other RGB signals within a horizontal frequency range of 15.625 to 85 kHz and a vertical frequency range of 50 to 85 Hz. This includes NTSC, PAL, SECAM and NTSC4.43 standard video signals.
Note: Composite video standards are as follows:
NTSC: | U.S. TV standard for video in U.S. and Canada. |
PAL: | TV standard used in western Europe. |
SECAM: | TV standard used in France and Eastern Europe. |
NTSC4.43: | TV standard used in Middle East countries. |
|
|
•The remote control can be used with or without a cable, and you can even use the remote to operate your PC or Macintosh mouse wirelessly from across the room with the
•You can control your MultiSync MT830/1030 LCD Pro- jector with a PC.
•The contemporary cabinet design is compact, easy to carry, and complements any office, board room or audito- rium.
•Eight kinds of pointers are available for your presentation.
*1 Installing the MultiSync MT830/1030 LCD Projector on the ceiling must be done by authorized NEC technicians. Consult your NEC dealer for more information.
*2 An XGA image (1024×768) is converted into an 800×600 crisp image with NEC technology's AccuBlend.
*3 An SXGA image (1280×1024) is converted into a 1024×768 crisp image with NEC technology's AccuBlend.
