Winegard WI-DM04, WI-DM54 owner manual Roof Template

Page 6

	Roof Template
ALIGN WITH
BASEPLATE
AREA MARKED
“FRONT”
POINT TO FRONT
OF VEHICLE

1-3/4” DIA.

DRILL COMPLETELY THROUGH CEILING

1/8” DRILL BIT

8 HOLES. DO NOT

DRILL THROUGH CEILING.

Image 6

Contents Installation Instructions WinegardDO’S Tuning AntennaOperation Lowering Antenna to Travel PositionTrouble Shooting Installation & AssemblyThings YOU Need Approximately 2 to 2-1/2 of the vent tube extending from Inside RVIs shown in A. Caution do not seal hole Tube end to hold in placeSee template on reverse side Roof Template Point to Tighten screw snuglyDigital Elevation Sensor Interior Wallplate Parts ListImproper wiring will cause Damage to the product Display CodesRK-CEIL InteriorHardware KIT Crank Handle KIT RK-HANDSpecifications Antenna & MountReturn Authorization Policy