Choosing a Location for the Antenna
1.For best performance and to reduce signal acquisition time, park the vehicle on a level surface that is free of obstructions such as trees or large buildings. Make sure you have a clear view of the southern sky.
2.Before removing the TRAV’LER antenna from its box, contact your RV dealer or manufacturer. Your RV may be pre- wired or have a reinforced area for this system.
3.Then, choose a location on the roof that meets the following requirements:
a. Offers enough support for a secure installation
R
e
|
|
|
|
|
|
| t |
|
|
|
|
|
| o | |
|
|
|
|
| N |
| |
|
|
|
| ( |
|
| |
|
|
|
| r |
|
|
|
|
|
| o |
|
|
| |
|
|
| t |
|
|
|
|
|
| c |
|
|
|
| |
| e |
|
|
|
|
| |
l |
|
|
|
|
|
| |
f |
|
|
|
|
|
|
|
Yet
Att a c h e d )
b. Allows dish to raise and rotate without interference from other
c. Has a minimum roof space of 42” x 25” for the antenna (see fig. 4)
d. Lacks obstructions taller than 8” mounted within a
25″ 32.5” radius from the center of the TRAV’LER base
R e f l e c tor
Center of Base
(N
ot
|
|
|
|
|
| e |
|
|
|
|
| h | |
|
|
|
| c |
| |
|
|
| a |
| ||
|
| t |
|
| ||
|
| t |
|
|
| |
| A |
|
|
|
| |
t |
|
|
|
|
| |
Ye |
|
|
|
|
|
|
d
)
e. Has a gap of less than 3/16” between the bottom
of the antenna and the roof
WARNING Do not install the antenna in a location where a gap of 3/16” or
more exists between the bottom of the antenna and the roof, as the antenna may damage the roof
42″
FIGURE 4. Required roof space for antenna
f.Is within 5 degrees of level, or the system may require more time to locate satellites (for best operation, must be within 3 degrees of level)
Choosing a Location for Cables to Enter the Vehicle
Once you have chosen a location for the TRAV’LER antenna, choose a location for the cables to enter the vehicle. Keep in mind the following:
1.The TRAV’LER interface box must plug into a
2.The 24” AC power cord must be long enough to extend from the outlet to the interface box power supply, which will then connect to the interface box.
3.The 30’ control cable must be long enough to extend from the mount base to the interface box.
4.One 30’ coax cable will need to be run from the mount base to each receiver inside the vehicle. Note that the provided coax cables only include a connector on one end.
5.Wires should not be run through the striped area (see fig. 5). Anything in the striped area will interfere with the operation of the TRAV’LER antenna and may cause damage to the object or to the antenna.
FIGURE 5. Marked area of antenna where cables should not be run
Make sure cables are long enough to reach their destination points inside the vehicle. For cable runs longer than 30’, an extension may be purchased. Winegard recommends using Model
WARNING Winegard is NOT liable for damage, expenses, or injury caused by improper installation.
Sold Separately
3