Troubleshooting
ANTENNA CONNECTION FAILED | Check the data cable connection on the back of the interface box. It may not be |
| connected properly. |
|
|
EL HOME FAILURE | Something is preventing the mount from raising as it attempted to find the |
| HOME position. Look for obstructions if the unit has recently been manually |
| raised or if the electronics have been replaced. The calibration may need |
| to be reset. Contact Winegard Technical Support at help@winegard.com or |
| |
|
|
AZ MOTOR STALLED | Something is preventing the mount from rotating; look for obstructions. If |
| there is no obvious obstruction, contact Winegard Technical Support at help@ |
| winegard.com or |
|
|
EL MOTOR STALLED | Something is preventing the mount from raising or lowering; look for |
| obstructions. If there is no obvious obstruction, contact Winegard Technical |
| Support at help@winegard.com or |
|
|
SK MOTOR STALLED | Something is preventing the reflector and LNBF from rotating; look for |
| obstructions. If there is no obvious obstruction, contact Winegard Technical |
| Support at help@winegard.com or |
|
|
STOW FAILURE | The TRAV’LER antenna is not stowed. Do not try to move the vehicle. Try to |
ANT NOT STOWED | stow the TRAV’LER antenna again. If it fails again, check for obstructions. |
|
|
STOW FAILURE | Check the data cable connection on the back of the interface. It may not be |
STOW UNKNOWN | connected properly. |
|
|
AZ MOTOR RUN REVERSE | Contact Winegard Technical Support at help@winegard.com or |
|
|
EL MOTOR RUN REVERSE | Contact Winegard Technical Support at help@winegard.com or |
|
|
SK MOTOR RUN REVERSE | Contact Winegard Technical Support at help@winegard.com or |
|
|
AZ MOTOR RUNAWAY | Contact Winegard Technical Support at help@winegard.com or |
|
|
EL MOTOR RUNAWAY | Contact Winegard Technical Support at help@winegard.com or |
|
|
SK MOTOR RUNAWAY | Contact Winegard Technical Support at help@winegard.com or |
|
|
NO LNB VOLTAGE | The TRAV’LER antenna is not seeing the required |
| the LNBF. Check the coax connections. If these are all connected properly, |
| contact Winegard Technical Support at help@winegard.com or |
|
|
UNKNOWN ERROR ###### | Contact Winegard Technical Support at help@winegard.com or |
|
|
C MOTOR NOT FOUND | Contact Winegard Technical Support at help@winegard.com or |
|
|
ANTENNA WILL NOT | See emergency manual stow instructions on page 1 of the operation manual. |
AUTOMATICALLY STOW. |
|
Weather and vehicle location can impact the ability of the TRAV’LER antenna to locate all of the required satellites. Obstructions such as buildings or tree limbs can block the satellite signals and prevent the TRAV’LER antenna from successfully locating all of the satellites during automatic operation. Make sure you have a clear view of the southern sky.
3