Winegard MV-3500 manual Parts Included Tools Needed How to Unpack, Unpacking the Unit

Parts Included • Tools Needed • How to Unpack

PARTS INCLUDED:

1	Radome	1 Cable entry plate
3 base mounting feet		1 large yellow spade connector
1 Power switch		2 small red spade connectors
2	Wall plates (white & brown)	All required screws and washers
1	Surface mount box	1 base with electronics, dish, dual LNBF
2	Cable clamps	1 tube silicone

TOOLS NEEDED FOR UNPACKING & INSTALLATION:

7/16” open end wrench Level

Drill w/3/4” bit

1-1/4” hole saw (if mounting switch in wall) 5/16” Socket for roof screws

1/8” Allen wrench

UNPACKING THE UNIT

1. Open box and remove packing material.

If using knife to open

!carton, BE CAREFUL. Do not cut the dome on the unit.

2.Lift unit out of box vertically. Do not turn box and “roll” out, or turn upside down to remove.

1/2” Open end wrench

Crimping tool for coax connections Crimping tool for electrical connections Small blade screw driver

Pliers

Sealant (consult RV manufacturer for proper type for your roof material)

LIFT UNIT STRAIGHT UP

USE 2 PEOPLE

when removing the unit from the carton.

6