Winegard 1000 manual Removing the Reflector and LNB Assembly, Reflector nut not shown, Turret

Page 3

Removing the Reflector and LNB Assembly

1If converting a DIRECTV SWM Slimline antenna to a DISH TRAV’LER antenna, remove the power inserter and SWM splitter; these will not be used.

2Remove the four reflector nuts and bolts, and remove the dish. Set the nuts and bolts aside.

3Disconnect the coaxial cables from the turret. Note that the D port will not be present on a SWM TRAV’LER antenna.

4Remove the bolt holding the cable harness to the unit, and detach the cable harness from the lift arm.

Bolt	Lift
	Arm

Cable harness

5Set the bolt aside; you will need this later.

Image 3

Contents Replacement Dish LNB Assembly Unplug the TRAV’LER interface, and remove Raising the AntennaRemoving the Reflector and LNB Assembly Reflector nut not shownTurret Bolts Installing the Dish Reflector and LNB AssemblyReflector bracket Skew housing Stiffener PlateCap TIPSetting the IDU for Dish Re-packaging the Removed LNB for OE-DISH Users Re-packaging the Removed LNB for RP-SK21 Users