1Align the four holes on the inside of the reflector bracket with the four marked holes in the adaptor plate. See image below for the holes to align with the reflector bracket and adaptor plate. The numbers on the reflector bracket and adaptor plate should match.
|
| 1 |
| 1 |
|
|
|
| |
| 4 | 2 | 4 | 2 |
|
| |||
|
| 3 |
| 3 |
TIP | The bracket should be installed so that the LNB |
| ||
arm assembly is at the bottom of this plate. | 1 | |||
2Replace the supplied 3/16 Allen screws through
| these four holes, and tighten. | 4 | 2 |
|
| ||
3 | After the bracket has been installed, connect and |
| 3 |
|
| ||
| tighten the coaxial cables. These can be |
|
|
| in any order, but port D should be left open. |
|
|
4 | Install the provided |
|
|
| be used if converting from a SWM TRAV’LER antenna. |
| |
|
|
|
5Find the cable tie on the coax cables that you just connected to the mount. Place the coax cable clamp on the cables just above this cable tie. Carefully screw this coax cable to the lift arm using the 5/16 inch screw provided.
Be careful not to strip out the hole for the 5/16 inch screws when you replace the clamp holding the coax cables to the arm. Do not user a power tool.
NOTE If the cable tie is missing, install the clamp fourteen inches from the end of the connectors.
6Align the four outer holes in the reflector bracket with the four corresponding holes in the reflector. Install a bolt through each hole on the front of the reflector, and install a nut on each bolt. Tighten.
7Use the provided packaging to