Perle Systems c-1111-xxxxx manual Installing or Replacing Media Converter Modules, Loopback Switch

Page 10

Loopback (Switch 7)

Switch Position

Mode

 

 

Up (default)

Disabled

 

 

Down

Enabled

 

 

Disabled: This is the setting for normal operation. The switch must be set to this position in order for data to pass through the Media Converter Module.

Enabled: This is a test mode. All data received on the receive (RX) fiber connection is looped back to the transmit (TX) fiber connection. The state of the copper link is not relevant since no data is passed through to the copper side. This mode will override all other switch settings.

Installing or Replacing Media Converter Modules

Caution: Observe electrostatic discharge precautions when installing the Media Converter Module(s) into the Chassis. Failure to observe this caution could result in damage to the Media Converter Module(s) and /or chassis.

The Perle Media Converter Modules can be installed in any available slot and in any order within the chassis.

1.Remove the Media Converter Module from its packaging.

2.Using a cross-head screwdriver, remove the screw holding the face plate to the Chassis to reveal the slot opening.

3.Set the jumpers and DIP switches on the Media Converter Module to the desired operating mode.

4.Locate the top and bottom alignment guides inside the Chassis.

5.Using the module alignment guides gently slide the module into the slot until it becomes flush with the front of the Chassis. Light pressure may be needed to seat the module. Do not force the module as you might cause some damage. If there is resistance, remove the module, check the module connector for damaged or incorrectly aligned pins, if there is no damage, retry to insert the module.

10

Perle 10/100/1000 Media Converter Module – Instal lation Guide

Image 10
Contents CM-1110-XXXXX Managed Module 1110-SFP Installation GuideXxxxx CM-1110-SFP Managed ModuleMode Distance Wavelength OverviewSFP Installation Auto-MDIX JumperAuto-Config Jumper CM-1110 only Dip SwitchesLink Mode Switch Auto Negotiation copper SwitchSwitch Position Mode Fiber Fault Alert Switch Duplex copper Switch Speed copper Switch Fiber Negotiation SwitchInstalling or Replacing Media Converter Modules Loopback SwitchInstalling the Duplex Fiber Cable Installing the SFP Fiber ModuleRemoving Media Converter Modules Installing the Simplex Fiber Cable Installing the Copper CableOperation Status LEDAuto-MDIX Other FeaturesError Recovery Pause Ieee 802.3xyGeneral TroubleshootingNo connectivity Technical Specifications Fiber Optic SpecificationsFiber Cabling Requirements Ethernet Copper Cabling RequirementsEN 55022, Class a EN 55024, Class a Laser Safety IEC Compliance InformationWarranty / Registration Copyright