Remote Controller Preparation
Others
Install the batteries into the remote controller to operate the DVD player.
1 | 1. Open the cover. |
Operate with the remote controller correctly.
Point the remote controller at the remote sensor and press the button.
(The pictures of player and remoter are only for reference)
2 | 2. Insert batteries (R03). |
Make sure to match the "+" and
3 | 3. Close the cover. |
Notes:
Improper use of batteries may cause battery leakage and corrosion. To operate the remote controller correctly, follow the instruction below.
Do not insert batteries into the remote controller in the wrong direction.
Do not charge, heat, open, or
Do not throw batteries into a fire.
Do not leave dead or exhausted batteries in the remote controller.
Do not use different types of batteries together or mix old and new batteries.
lf you do not use the remote controller for along period of time remove the batteries to avoid possible damage from battery corrosion.
If the remote controller does not function correctly or the operating range become reduced, replace all batteries with new ones.
If battery leakage occurs, wipe the battery liquid from the battery compartment, then insert new ones.
Distance: About 7m from the front of the remote sensor.
Angle: About an angle of 30 in each direction of the front of the remote sensor.
Remarks: Do not expose the remote sensor of the DVD player to strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD player via the remote controller.
Notes:
Direct the remote controller at the remote sensor of the DVD player.
Do not drop or give the remote controller a shock.
Do not leave the remote controller near an extremely hot or humid place.
Do not spill water or put anything wet on the remote controller.
Do not open the remote controller.
If the remote controller function correctly, the usage life of the battery is about one year.