Palsonic DVD2030 Remote Control Preparation, Point the remote control at the remote sensor

Remote Control Preparation

Other

	Insert batteries	Using the remote control
		Point the remote control at the remote sensor.
1	1. Open the cover.
		(The pictures are only for reference)

OPEN/CLOSE PLAY/PAUSE STOP R/L POWER

22. Insert batteries.

3 0 o

Make sure to match the "+" and "-" of the batteries with the marks inside the battery compartment.

o 30

33. Close the cover.

Notes:

Improper use of batteries may cause battery leakage and corrosion. To operate the remote controller correctly, follow the instruction below.

Do not insert batteries in the wrong direction.

Do not charge, heat, open, or short-circuit the batteries.

Do not throw batteries into a fire.

Do not leave dead batteries in the Remote Control.

Do not use different types of batteries together or mix old and new batteries.

If you do not use the remote control for a long period of time, remove the batteries to avoid possible damage from battery corrosion.

If the remote control does not function correctly or the operating range become reduced, replace all batteries with new ones.

If battery leakage occurs, clean the battery compartment, then insert new ones.

Remarks: Do not expose the remote sensor of the DVD Player to strong light source such as direct sunlight.

Notes:

Point the remote control at the players remote sensor.

Do not leave the remote control near an extremely hot or humid place.

Do not spill water or put anything wet on the remote control.

Battery life is 1 year under normal conditions.

29