Palsonic DVD2030 user manual Outdoor Antenna Grounding

Page 5

Important Safety Instructions

Introduction

15. OUTDOOR ANTENNA GROUNDING

If an outside antenna or cable system is connected to the product, be sure the antenna or cable system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure below.

20. SERVICING

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel.

21. DAMAGE REQUIRING SERVICE

Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions:

A)When the power-supply cord or plug is damaged,

B)If liquid has been spilled, or objects have fallen into the product,

C)If the product has been exposed to rain or water,

D)If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation,

E)If the product has been dropped or damaged in anyway, and

F)When the product exhibits a distinct change in performance this indicates a need for service.

16. LIGHTNING

For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall out let and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power lines surges.

17. POWER LINES

An outside antenna system should not be located in the vicinity of over head power lines or other electric light or power circuits, or where it can fall in to such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as contact with them might be fatal.

18. OVERLOADING

Do not overload wall outlets, extension cords, or integral convenience receptacles, as this can result in a risk of fire or electric shock.

19. OBJECT AND LIQUID ENTRY

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

22. REPLACEMENT PARTS

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristics as the original part. Unauthorised substitutions may result in fire, electric shock, or other hazards.

23. SAFETY CHECK

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

24. WALL OR CEILING MOUNTING

The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

25. HEAT

The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

4

Image 5
Contents DVD2030 Introduction ContentSafety Precautions Cleaning Important Safety InstructionsOutdoor Antenna Grounding Introduction 169 FeaturesFront Panel Display Display the players status IR Sensor Front Panel and Rear Panel IllustrationFront panel Remote Control Connections Connecting to a TV SetYellow Video Amplifier Connecting to an AV Amplifier with Digital Audio Output Basic Playback Basic OperationAdvanced Features Modes and Features SetupLanguage Setup Video Setup Down sampling Audio SetupAC-3 Setting Rating Setup Remote Control Operation Display Time Press Play to resume normal playback Play When playback is stopped Slow Step Repeat Return VOL+ VOL PBC Mute During CD/VCD/SVCD playback File window MP3 PlaybackZoom Function General functionPoint the remote control at the remote sensor Remote Control PreparationOpen the cover Insert batteriesSpecifications TroubleshootingPalsonic Customer Service Telephone