Memorex MLT2022 manual Troubleshooting Guide, Symptom Possible Cause Possible Solution Power

TROUBLESHOOTING GUIDE

Check the following before requesting service:
SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION
POWER
No power.	The AC adapter/cord is not connected.	Connect the AC adapter/cord properly.
	Main Power switch not in On (I) position.	Press Main Power switch to On (I) position.
TV BROADCAST RECEPTION
Poor or no picture.	TV station experiencing problems.	Try another channel.
	Picture control is not adjusted.	Check picture control adjustments.
	Possible local interference.	Check for source of reception disturbance.
	Antenna/CATV connector is not connected.	Check CATV connection or VHF/UHF antenna.
Picture wobbles or drifts.	TV station experiencing problems.	Try another channel.
	Cable TV channel is scrambled.	A Cable box needs to be used (if desired).
	Possible local interference.	Check for source of reception disturbance.
No CATV reception.	CATV connected improperly or not connected.	Check all CATV connections.
	TV SYSTEM option set to AIR.	Set SYSTEM option to CATV.
	Cable TV service interrupted.	Contact your Cable TV company.
No reception above ch13.	TV SYSTEM option set to AIR.	Set SYSTEM option to CATV.
	TV station experiencing problems.	Try another channel.
Poor or no sound.	MUTE button is pressed.	Press MUTE button again.
	Possible local interference.	Check for source of reception disturbance.
	Antenna/CATV connector is not connected.	Check CATV connection or VHF/UHF antenna.
	Volume is set to minimum.	Increase volume.
TV shuts off.	TV station stopped broadcasting.	Tune to a new channel.
	Sleep Timer is set.	Set Sleep Timer to Off.
Closed Captioning not	TV signal is weak.	Check CATV or VHF/UHF antenna connection.
	TV station experiencing problems or	Try another channel.
working.	program tuned is not closed captioned.
REMOTE CONTROL	Closed Captioning not turned on.	Turn Closed Captioning on.
	Distance is too far or too much	Operate within 15 feet or reduce
Remote control does	light in the room.	the light in the room.
	There is an obstacle in the path of the beam	Clear the path of the beam and/or aim the remote
not operate.	or remote is not aimed at the sensor.	at the sensor.
	The batteries are weak or installed incorrectly.	Replace the batteries or install correctly.
PARENTAL CONTROL (V	-CHIP)
	V-Chip setting is turned off.	Turn V-Chip setting on.
Parental control	News or sports event being broadcast.	Parental Control does not work with news or
protection is not		sporting events.
working properly.
	Ratings not set.	Set ratings as desired.

32